高度旋鈕

Turn the knob to set a new target altitude that the autopilot is allowed to fly to.

Pushing the altitude knob performs a managed climb (CLB) or descent (DES) towards the selected altitude when you have a route programmed. It does nothing if there is no route nearby and it only works if you are already flying along the route in NAV mode. With this mode the autopilot will automatically level off at altitude constraints if the flight plan requires that.

Pulling the altitude knob tells the autopilot to immediately climb or descent to the selected altitude without any restrictions in open climb (OP CLB) or open descent (OP DES) modes.

旋轉旋鈕以設置允許自動駕駛儀飛行的新目標高度。

設定了路線后，按海拔高度旋鈕可向選定的海拔高度執行受控爬升(CLB)或下降(DES)。如果附近沒有路線，它什么也不做，只有在您已經以NAV模式沿著路線飛行時，它才起作用。在這種模式下，如果飛行計劃需要，自動駕駛儀將在高度限制條件下自動平放。

拉動高度旋鈕，可讓自動駕駛儀立即爬升或下降到選定的高度，而在開放爬升(OP CLB)或開放下降(OP DES)模式下沒有任何限制。